This is the ElectriFly Silver Series 8A Brushless Electronic Speed Control. Great for small, lightweight, high performance airplanes from flat-foams to built-up 3Ds. Great for Outrunner style Brushless Motors, delivering 8A of continuous current with a built-in Battery Eliminator Circuit which can handle 1.5A. Simple to use and very affordable.

FEATURES:

Compatible with NiCd, NiMH and LiPo batteries
Auto-detects input volts and sets Low-Voltage cutoff
8.5kHz switching frequency, for good run-time and cool operation
Pre-installed Universal radio connector* (see Comments below)
Pre-installed polarized micro connector for battery
Pre-installed gold plated 2mm female bullet connectors for motor
High powered switching BEC (Battery Eliminator Circuitry) which handles 2 or 3 micro servos (4 if adequate airflow is provided)
Full proportional forward and smooth throttle response with ON/OFF brake Safe Start System** (see details in Comments below)
Thermal Protection stops motor when maximum temperature 230°F is reached

REQUIRES:

Mating motor connectors, GPMM3110
Mating battery connector, WSDM3007

SPECS:

Length: 1.18" (30mm)
Width: .79" (20mm)
Height: .24" (6mm)
Weight: .39oz (11g)
Input Voltage: 6-12 cells NiCd/NiMH 2-4 cells LiPo (20V input w/o BEC)
Output Current: 8A continuous maximum 10A surge maximum
Max Output Power: 100 watts
On-resistance: .05 ohms
Operating frequency: 8.5kHz
BEC: 5V/1.5A
Low Voltage Cutoff: Battery voltage x .67
Thermal Cutoff: 230°F (110°C)
Timing Angle: 12°
Brake: ON/OFF